無磷膜阻垢劑ProtecMBC? 1513

    性能與用途

膜阻垢劑ProtecMBC^? 1513是一種無磷高效阻垢劑，適用于反滲透（RO）系統及納濾（NF）和超濾（UF）系統中，可防止膜表面結垢，能提高系統產水量及產水質量，降低運行費用。

膜阻垢劑ProtecMBC^? 1513的特點：

（1）可用于反滲透CA及TFC膜、納濾膜和超濾膜；

（2）良好的溶解性及穩定性，通過顆粒分散，保持膜表面的清潔；

（3）水解穩定性好，給水pH值在5-9范圍內均有效

（4）采用無磷配方，一方面可以減少細菌滋生和磷酸鹽沉淀污染，另一方面可以滿足環保排放要求

（5）不與鐵鋁及其氧化物凝聚形成不溶物。

    產品技術指標

使用方法

膜阻垢劑ProtecMBC^? 1513的加藥劑量是根據系統水質分析報告以及系統運行情況計算確定的，一般加藥量5-8mg/L。可以稀釋或原液投加，若稀釋投加，稀釋水是RO產水或除鹽水，推薦稀釋倍數不超過10倍。每隔5-7天重新配制一次藥劑，注意在重新配制藥劑之前，應清洗藥箱，防止微生物的滋生。

    包裝與貯存

    膜阻垢劑ProtecMBC^? 1513一般采用塑料桶包裝，25kg/桶；或根據客戶具體要求而定。

    安全與防護

    操作時注意勞動保護，應避免與皮膚、眼睛等接觸，接觸后用大量清水沖洗。

Membrane Scale Inhibitor ProtecMBC?1513

1.Performance and Application

The membrane anti-scaling agent ProtecMBC^?1513 is a high-efficiency, phosphorus-free anti-scaling agent suitable for reverse osmosis (RO) systems, as well as nanofiltration (NF) and ultrafiltration (UF) systems. It prevents scaling on membrane surfaces, enhances system water output and quality, and reduces operating costs.

Features of the membrane anti-scaling agent ProtecMBC^?1513:

(1)Suitable for reverse osmosis CA and TFC membranes, nanofiltration membranes, and ultrafiltration membranes.

(2)Excellent solubility and stability, maintains membrane surface cleanliness through particle dispersion.

(3)Good hydrolytic stability; effective within a feed water pH range of 5-9.

(4)Phosphorus-free formulation, which reduces bacterial growth and phosphate precipitation, and meets environmental discharge requirements.

(5)Does not form insoluble compounds with iron, aluminum, or their oxides.

2. Product Technical Specifications

3.Usage Instructions

The dosage of the membrane anti-scaling agent ProtecMBC^?1513 is determined based on the system water quality analysis report and operating conditions, with a typical dosage of 5-8 mg/L. It can be added either as a diluted solution or in its original form. If diluted, use RO permeate or deionized water, with a recommended dilution ratio not exceeding 10 times. Reprepare the solution every 5-7 days, and ensure that the dosing tank is cleaned before preparation to prevent microbial growth。

4. Packaging and Storage

   The membrane anti-scaling agent ProtecMBC^?1513 is typically packaged in plastic barrels, 25 kg per barrel, or according to specific customer requirements.

5. Safety and Protection

    During operation, ensure proper labor protection. Avoid contact with skin and eyes. In case of contact, rinse thoroughly with plenty of water.